Next, we'll have to configure the pluggable authentication modules (PAM) to also use LDAP-Authentication as auth-source. Open up the file in your favorite editor and change it like so: Yes it's working but what if, I have a hotspot running in Raspberry pi and on a VLAN bridge connected to mikrotik. Also tried using GNS3 cisco router & export it to. Mikrotik PPPOE and hotspot at the same interface. it collects Netflow data from RB750 (its called Traffic Flow on the IP > Traffic Flow Menu). Next up is the name service switch file where we'll need to add a few things. Answer (1 of 3): Hi, I saw some post that it's already working. Uri ldap:// # for authentication requests,īase dc=archyslife,dc=lan # This base will be used for all queries. A Raspberry Pi (Raspberry Pi 1 Models A+ and B+, Pi 2 Model B, Pi 3 Models A+, B and B+, and Pi Zero and Zero W GPIO J8) device with an active internet connection. Uri ldap:// # My ldap-servers which are queried Gid nslcd # The group which nslcd will run as Edit the /etc/nf in your favorite ~]$ sudo vim /etc/nf uid nslcd # The user which nslcd will run as When the installation is complete, we'll need to edit the config. You'll have to start by installing the necessary package in this case, which is ~]$ sudo apt-get -y install libnss-ldapd So here is what I did to get it working with raspbian 9. Recently I've deployed a few raspberry pi nodes running raspbian and I did not want to have local users (except the 'pi' one) but have it using ldap for authentication.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |